Broom Angle - Honda FS7054 Operator's Manual

OPERATION

BROOM ANGLE

Broom angle can be changed from the operator's position by using engine power to move the power unit.
1. Put the blade control lever in the OFF position.
2. Turn the T-handle counterclockwise 1/4-turn to unlock the cable. Raise it to the up position and turn it
clockwise 1/4-turn to lock it in the up position.
3. Use the directional control levers to move the power unit and pivot the broom to the desired angle.
4. After the desired angle has been achieved, turn the T-handle counterclockwise 1/4-turn to unlock it
and allow it to return to the down position.
5. Slowly alternate the directional control levers. to be sure the sweeper swing pin drops all the way down
and is fully engaged with the mounting frame. With the T-handle all the way down, turn it clockwise
1/4-turn to lock it in the down position.
SWING PIN
14
FS7054 FRONT SWEEPER