Honda WB3OX Owner's Manual

Honda WB3OX Owner's Manual

Honda water pump owner's manual wbzox, wb3ox

Advertisement

Advertisement

Table of Contents
loading

Summary of Contents for Honda WB3OX

  • Page 3 Read and understand the pump. Failure to do so could result in personal in- from your authorized Honda pump dealer. of WBZOX and WB3OX is based on the latest without written permission. part of the pump and should...
  • Page 4: Table Of Contents

    CONTENTS 1. SAFETY INSTRUCTIONS 2. COMPONENT IDENTIFICATION 3. PREPARATION 4. STARTING THE ENGINE ... 5. OPERATION 6. STOPPINd THE ENGINE ... High altitude operation 7. MAINTENANCE 8. TRANSPORTING/STORAGE 9. TROUBLESHOOTING 10. SPECIFICATIONS 1 1. WARRANTY SERVICE ..: 24...
  • Page 5: Safety Instructions

    To ensure safe operation- . For safety, never pump flammable acid. Also, to avoid pump corrosion, chemical solutions, Place the pump on a firm, level surface. fuel spillage may result. To prevent fire hazards and to provide adequate ventilation, at least 1 meter (3 feet) away from buildings operation.
  • Page 6 < CAUTION LABEL LOCATION > GASOLINE CAUTION LABEL UMP FLAMMAB OR CORROSIVE MATERIALS. AN EXPLOSION OR FIRE PUMP CAUilON LABEL !~~!
  • Page 7: Component Identification

    < WB20X> MUFFLER ENGINE SWITCH 2. COMPONENT CARRYING HANDLE FUEL IDENTIFICATION FUEL FILLER CLEANER THROTTLE CHOKE LEVER STARTER VALVE PRIMING WATER FILLER PUMP DRAIN LEVER GRIP...
  • Page 8 < WB3OX > FUEL FILLER DISCHARGE PORT CHOKE LEVER STARTER GRIP ENGINE SWITCH MUFFLER FRAME PRIMING WATER- FILLER CLEANER SUCTION PORT PUMP DRAIN CAP/ Al-x ST\RAINER FILLER CAP/ 01 L DRAIN PLUG DIPSTICK...
  • Page 9: Preparation

    1. Connect the suction .Use commercially available tion hose must be of reinforced, length should not be longer than necessary, when the pump is not far above the water level. Self-priming portional to hose length. The strainer that is provided the suction hose with a band, as shown.
  • Page 10 3. Check the engine oil level. CAUTION: Engine oil is a major factor affecting Nondetergent oils and 2-stroke have inadequate lubricating Be sure to check the engine on a level surface with the engine stopped. Use Honda 4-stroke oil, or an equivalent high detergent, premium certified...
  • Page 11 4. Check the fuel level. Your engin; ‘+” @signed ) of number tane number if 91 or higher. display the pump octane We recommend that engine and spark plug deposits components. Never use stale or contaminated getting dirt, dust or water can cause persistent “pinging”...
  • Page 12: Starting

    Gasoline is extremely Refuel in a well-ventilated allow flames or sparks in the area where the engine is refueled gasoline is stored. Do not overfill the fuel tank (there should be no fuel in the filler neck). After refueling, make sure the tank cap is closed properly Be careful not to spill fuel when refueling.
  • Page 13 5. Check the air cleaner element. Remove the wing nut, washer Check the element for dirt or obstruchtion. Clean the element CAUTION: Never run the engine wear will result from contaminants, through the carburetor, AIR CLEANER COVER CLEANER ELEMENT 6. Check the priming water. The pump chamber CAUTION: Never attempt...
  • Page 14: Starting The Engine

    4. STARTING THE ENGINE 1. Turn the fuel valve ON. 2. Close the choke lever. the engine is warm or the ambient NOTE: Do not use the choke temperature is high. CHQKE LEVER ; FUEL VALVE 3. Turn the engine switch to‘the ON position.
  • Page 15 4. Move the throttle lever slightly to the left. THROTTLE LEVER 5. Pull the starter grip lightly until resistance is felt, then pull it briskly. CAUTION: Do not allow the starter grip to snap back against the engine. Return it gently to prevent damage to the starter. STAliTER GRIP...
  • Page 16: Operation

    5. OPERATION 1. As the engine warms up, gradually open the choke. 2. Set the throttle at the desired speed. THROTTLE LEVER...
  • Page 17: Stoppind The Engine

    6. STOPPING THE ENGINE 1. Move the throttle lever fully to the right. 2. Turn the engine switch to the OFF position. THROTTLE LEVER 3. Turn the fuel valve OFF. FUEL VALVE NOTE: To stop the engine in an emergency, turn the engine switch to the OFF position.
  • Page 18: High Altitude Operation

    High altitude operation At high altitude, the standard rich. Performance will decrease, High altitude performance main fuel jet in the carburetor operate the water pump at altitudes have your authorized modifications. Even with suitable carburetor imately 3.5% for each 1,000 foot increase in altitude. horsepower will be greater than this if no carburetor CAUTION:...
  • Page 19: Maintenance

    The purpose of the maintenance engine in the best operating table below. Shut off the engine engine must be run, make sure the area is well ventilated. tains poisonous carbon sciousness and may lead to death. CAUTION: If the pump has been used with sea water, muddy water, etc., pump clean, fresh water through and remove sediment.
  • Page 20 1. Changing oil Drain the oil while the engine draining. 1. Remove the oil filler cap and the drain plug, then drain the oil. 2. Reinstall the drain plug and tighten securely.. 3. Refill with the recommended 01 L CAPACITY: 0.6P (0.63 US qt) DRAIN PLUG...
  • Page 21 2. Air cleaner service A dirty air cleaner will restrict air flow to the carburetor. To prevent carburetor malfunction, service air cleaner regularly. Service more frequently when operating the pump in extremely dusty areas. Never use gasoline or low flash point solvents for cleaning the air cleaner element.
  • Page 22 3. Spark plug service Recommended spark plug: To ensure proper engine operation, and free of deposits. 1. Remove the spark plug. If the engine has been running, careful not to touch the muffler, MUFFLE 2. Visually inspect the spark plug. Discard it if the insulator chipped.
  • Page 23 4. Thread the plug in by hand to prevent cross-threading. plug l/2 turn with the wrench to compress the washer. 5. Tighten a new spark plug, it should only take l/8-1/4 turn after the plug If you are reusing a seats.
  • Page 24: Transporting/Storage

    8. TRANSPORTING/STORAGE When transporting pump level to prevent To avoid severe burns or fire hazards, let the engine cool before transporting the pump or storing it indoors. Before storing the pump for an extended 1. Be sure the storage area is free of excessive humidity 2.
  • Page 25 4. Pull the starter cord until resistance is felt. Continue on the starter pulley illustration below). At this point, and this will help to protect the engine from internal 5. Change engine oil. aligns with the hole the intake and exhaust valves are closed, Align the mark-on with.
  • Page 26: Troubleshooting

    9. TROUBLESHOOTUNG When the engine will not start: 1. Is the engine switch ON? 2. Is there enough fuel? 3. Is the fuel valve on? 4. Is gasoline reaching the carburetor? To check, remove the float bowl and turn the fuel valve on. Fuel should flow out free.
  • Page 27 When the pump does not pump water; 1. Is the pump fully primed? 2. Is the strainer clogged? 3. Are the hose bands installed 4. Are the hoses damaged? 5. Is the suction head too high? 6. If the pump still does not pump the water, take the pump to an authorized Honda water pump dealer.
  • Page 28 50 mm (2 in) 3,550 32 m (105ft) 8 m (27.9 ft) 500 Q (132 US gal)/min llOsecat5m (16.5ft) 2h 30 min WB3OX 515x400x450mm (20.3 x 15.7 x 17.7 in) 27.0 kg (59.5 lb) GX140 1 cylinder 144 cc (8.8 cu in) (2.5 PS/3,600 1 .O kg-m (7.7 ft-lb)/...
  • Page 29: 1. Warranty Service

    Owner Satisfaction Your satisfaction and goodwill Honda warranty details are explained Normally, any problems dealer’s service department. been handled to your action: Discuss your problem complaints can be quickly already been reviewed the dealership or the General If your problem still has not been resolved Power Equipment...
  • Page 30 MEMO...

This manual is also suitable for:

Wbzox

Table of Contents