Installing the Center Panel/Radio Unit
57. Check that the vehicle harnesses are not pinched
by the stays.
VEHICLE
HARNESS
STAY
© 2004 American Honda Motor Co., Inc - All Rights Reserved.
58. While holding the center panel with the radio unit
installed near the center panel opening, plug the
vehicle 20-pin connector, the antenna lead, the
heater control harness connector, and the bus
cable connector into the rear of the radio unit.
CENTER
PANEL
STAY
59. Reinstall the center panel.
AII 27936 (0408)
ANTENNA
LEAD
BOLT
(Tighten after
installing the
center panel.)
BUS CABLE
CONNECTOR
VEHICLE
CONNECTOR
BUS CABLE
CONNECTOR
ANTENNA
LEAD
VEHICLE 20-PIN
CONNECTOR
13 of 14