Debug Interface - Cisco Catalyst 3750 Command Reference Manual

Appendix B Catalyst 3750 Switch Debug Commands

debug interface

Use the debug interface privileged EXEC command to enable debugging of interface-related activities.
Use the no form of this command to disable debugging output.
Syntax Description interface-id
null interface-number
port-channel
port-channel-number
vlan vlan-id
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(11)AX
Usage Guidelines If you do not specify a keyword, all debug messages appear.
The undebug interface command is the same as the no debug interface command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you must start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member.
Related Commands Command
show debugging
show etherchannel
78-16181-01
debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
no debug interface {interface-id | null interface-number | port-channel port-channel-number |
vlan vlan-id}
Display debug messages for the specified physical port, identified by type
switch number/module number/ port, for example gigabitethernet 1/0/2.
Display debug messages for null interfaces. The interface-number is always
0.
Display debug messages for the specified EtherChannel port-channel
interface. The port-channel-number range is 1 to 12.
Display debug messages for the specified VLAN. The vlan-id range is 1 to
4094.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
Displays EtherChannel information for the channel.
Catalyst 3750 Switch Command Reference
debug interface
B-11