Switching Between The Cut-Sheet Feeder And The Push Tractor Does Not Work Properly; Using The Pull Tractor With The Push Tractor, Continuous Paper Does Not Feed Properly; With The Color Upgrade Installed, The Printer Does Not Operate Properly - Epson LQ-300 User Manual

Switching between the cut-sheet feeder and the push
tractor does not work properly
The desired paper type does not load.
The paper-release lever may not be in the proper position. Pull
the lever forward to load continuous paper or push the lever
back to load single sheets.
Using the pull tractor with the push tractor, continuous
paper does not feed properly
Paper feed is crooked or the paper jams.
The pull tractor and push tractor sprockets are not aligned
correctly. When using both tractors, be sure that the sprockets
on both are positioned evenly.
The paper may have too much slack. Adjust the position of the
sprockets to take up any slack along the width of the paper.
Remove slack lengthwise by rotating the knob of the pull
tractor.
The paper may be caught on the edge guides. Make sure that
the paper guide is installed over the paper and that the edge
guides are positioned correctly.
With the color upgrade installed, the printer does not
operate properly
The lights on the control panel do not go on.
The motor in the color upgrade kit may not be installed or may
not be installed correctly. Follow the instructions on page 2-35.
Troubleshooting
3-11