Using Vcr Plus+ To Record A Program - Hitachi VT-UX605A Owner's Manual

Basic Operations (VCR Plus + Recording)
If these codes do not work:
Try repositioning the cable box on top of the VCR and reentering the codes.
Try entering all code numbers (00 - 61). Press CLEAR on remote to change
incorrect entries.
If none of the codes work, press GUIDE to quit. The VCR will not control your
cable box. However, the output channel of the cable box has been set. Turn on
the cable box and leave it tuned to the channel you want to record some time
before the recording is to begin.

Using VCR Plus+ to Record a Program

Now that your channels are set up, you can take advantage of this quick and easy
method of delayed recording. You will use the on-screen Easy Guide System, following
the basic procedure for delayed recording outlined on page 41. See the section on
Recording a Program for recording tips and programming priorities.
You set up the delayed recording using the on-screen Easy Guide System.
1. Press the VCR PLUS+ to bring up this screen:
2. Use the number buttons to enter the PlusCode of the program you want to record.
This code can be up to eight digits. If you enter a wrong digit, press CLEAR and enter
the correct one.
3. If you accidentally enter a nonexistent PlusCode, the VCR gives you an error
message that disappears from the screen in about 10 seconds.
4. If you have entered the correct PlusCode, press VCR PLUS+ to store the PlusCode
in the VCR's memory. This brings up another screen:
- 47 -