Table of Contents
Advertisement
Draft Level—Hitachi Confidential
HiSpeed Memory, Boot Prom, Flash Components
The HiSpeed switch is shipped standard from the factory with the following
system configurations.
Memory:
8 Mbytes (DRAM)
Boot Prom:
512 Kbytes (EPROM)
— Initialization boot code
— Power-On Self-Test (POST)
— TFTP/FTP boot code
— Modem remote control
— Routines to load and execute compressed code
Flash: 4 Mbytes
— compressed system code
— compressed systems diagnostics
— system configuration data
— system traces (for debugging purposes)
Factory Switch Settings
The HiSpeed switches are shipped from the factory without any IP configurations
to the switch. To perform any routing and network management to the switch, you
must assign an IP address to a VLAN on the switch. Otherwise, the switch will
only provide core switching functionality. The factory default settings on the
switch are configured as follows:
Console speed is 9600
Login password is switch
All ports belong to VLAN 1
RIP is silent
Ethernet statistics are disabled
US7070447-001, Rev 01
Hardware Diagnostics
3-5
Advertisement
Table of Contents
Troubleshooting
