Part 3. How To Use The Ait Drive - Sony SDX-D250V Operator's Manual

Part 3. Operation
How to use the AIT Drive
16
Part 3. Operation
This section describes how to use the AIT drive, and how to handle data
cartridges.
1
Press the POWER switch on the front panel.
The POWER indicator should light, and the TAPE MOTION,
CLEANING REQUEST, and REPLACE TAPE indicators should blink
as the self-test is performed.
2
When the three indicators stop blinking, open the dust cover and insert a
data cartridge as shown below. The TAPE MOTION indicator lights.
3
Computer software controls the reading and writing of tapes. While
reading or writing, the TAPE MOTION indicator blinks.
4
Close the dust cover.