NETGEAR XAVB1101 Installation Manual

LED and Button Descriptions
Power LED
Ethernet LED
Powerline LED
Security
Reset
Item Description
• Solid green. The electrical power is on.
Power LED
• Blinking green. The adapter is in power saving
mode or setting up security.
• Off. There is no electrical power.
• Solid. The Ethernet port is linked, but there is no
Ethernet
activity.
LED
• Blinking. There is traffic on the Ethernet port.
• Off. There is no Ethernet connection.
• Solid. The adapter is connected to a Powerline
Powerline
network.
LED
• Blinking. The adapter is sending or receiving data.
• Off. The adapter has not found any other
compatible Powerline devices using the same
encryption key.
Item Description
The Pick A Plug feature lets you pick the electrical
outlet with the strongest link rate, indicated by the
color displayed by the LED:
Green: Link Amber: Link rate > Red: Link
rate > 80 Mbps 50 and < 80 Mbps rate < 50
(Best) (Better) Mbps (Good)
Factory Press the Reset button for 1 second, then release it to
Reset return the Powerline adapter to its factory default set-
tings.
Security After you plug in your new AV adapter, press the
Button Security button for 2 seconds, then press the security
button on one of the other AV adapters in your exist-
ing network for 2 seconds. Both buttons must be
pressed within 2 minutes.
Note: The Security button does not work in power
saving mode (see "Power LED is blinking once every 3
seconds" in the "Troubleshooting Tips" table below).
Warning: Do not press the Security button on the
Powerline adapter until installation is complete and the
adapters are communicating with each other (indicated by
the blinking Powerline LED). Pressing this button too soon
can temporarily disable Powerline communication. If this
should occur, use the Factory Reset button to return the
Powerline adapter to its factory default settings.

Troubleshooting Tips

Power LED is off Make sure that power is supplied to the electrical outlet,
and that the Powerline devices are not plugged into an
extension cord, power strip, or surge protector.
Power LED is Power saving mode occurs when the Ethernet LED is off.
blinking once This can occur when:
every 3 seconds • The Ethernet cable is unplugged.
• The device connected through the Ethernet cable is
turned off.
• The adapter is idle for 10 minutes.
It returns to normal mode within 2 seconds once the
Ethernet link is up.
Powerline LED is • If you have set network security, make sure that all Power
off line devices are using the same encryption key; see the
online User Manual for details.
• Press the Reset button on each device for 1 second to
return the Powerline adapter to its factory default settings.
Powerline LED is Move the Powerline device to a closer location.
amber or red
Ethernet LED is • Make sure that the Ethernet cables are working and
not blinking securely plugged into the devices.
• Press the Reset button on each device for 1 second to
return the Powerline adapter to its factory default settings.
This symbol was placed in accordance with the European Union Directive
2002/96 on the Waste Electrical and Electronic Equipment (the WEEE
Directive). If disposed of within the European Union, this product should be
treated and recycled in accordance with the laws of your jurisdiction
implementing the WEEE Directive.
©2011 by NETGEAR, Inc. All rights reserved. NETGEAR and the NETGEAR logo are
registered trademarks of NETGEAR, Inc. in the United States and/or other countries.
Other brand and product names are trademarks or registered trademarks of their
respective holders. Information is subject to change without notice.
Powerline AV 200 Mini
Adapter XAVB1101
Package Contents
Ethernet Cables
May 2011
Installation Guide
Powerline
AV 200 Mini
Adapters