To Operate On Hills - Husqvarna YTH22V42LS Operator's Manual

Ride-on mowers
Hide thumbs Also See for YTH22V42LS:
Table of Contents

Advertisement

Available languages

Available languages

TO STOP MOWER BLADES
Disengage at tach ment clutch con trol.
CAUTION:
without either the en tire grass catcher, on
mowers so equipped, or the deflector shield
(S) in place (See Fig. 10).
FUNCIONAMIENTO ATRÁS (ROS) (Vea Fig. 11)
Tu tractor está equipado con el Sistema de Funcionamiento Atrás
(ROS). Cualquier tentativa del operador de viajar marcha atrás
con el embrague puesto apagará el motor a menos que la llave
de ignición se ponga en la posición de "ON" del ROS.
ATENCIÓN: Ir marcha atrás con el embrague puesto para
cortar, no es recomendable. Poniendo el ROS en posición "ON",
para permitir el funcionamiento atrás con el embrague puesto, se
tiene que hacer sólo cuando el operador lo considera necesario
para reposicionar la máquina con el dispositivo embragado. No
siegue en revés a menos que sea absolutamente necesario.
USAR EL SISTEMA DE FUNCIONAMIENTO ATRÁS (ROS) -
Utilice el tractor solamente si está seguro de que no ingresarán
niños ni otras personas o animales al área donde se va a cortar
el césped.
Presionar el pedal freno hasta el fondo.
Con el motor en marcha, girar la llave del interruptor de la
ignición en el sentido inverso al de las agujas del reloj hasta
la posición "ON".
Mire hacia abajo y hacia atrás no sólo antes de ir marcha
atrás, sino mientras esté yendo marcha atrás.
Presione lentamente el pedal reverso de la impulsión para
comenzar el movimiento.
Cuando el uso del ROS es más necesario, dé vuelta a la
llave de ignición en el sentido de las agujas del reloj hasta
la posición "ON".
POSICIÓN
ROS "ON"
OPERATION
Do not operate the mower
S
Fig. 10
MOTOR EN POSICIÓN "ON"
(OPERACIÓN NORMAL)
Fig. 11

TO OPERATE ON HILLS

CAUTION: Do not drive up or down
hills with slopes greater than 15° and
do not drive across any slope.
Choose the slowest speed before starting up or down
hills.
Avoid stopping or changing speed on hills.
If stopping is absolutely necessary, push brake pedal
quickly to brake position and engage parking brake.
To restart movement, slowly release parking brake and
brake pedal.
Slowly depress appropriate drive pedal to slowest set ting.
Make all turns slowly.
TO TRANSPORT (See Figs. 3 and 12)
When pushing or towing your tractor, be sure to disengage
transmission by placing freewheel control in free wheel ing po-
si tion. Free wheel control is located at the rear drawbar of tractor.
Raise attachment lift to highest position with at tach ment
lift control.
Pull freewheel control out and down into the slot and
release so it is held in the disengaged position.
Do not push or tow tractor at more than two (2) MPH.
To reengage transmission, reverse above procedure.
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trailer, be sure hood is closed
and secured to tractor. Use an appropriate means of tying
hood to tractor (rope, cord, etc.).
TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
TOWING CARTS AND OTHER AT TACH MENTS
Tow only the attachments that are recommended by and
comply with specifications of the manufacturer of your trac-
tor. Use common sense when towing. Too heavy of a load,
while on a slope, is dangerous. Tires can lose traction with
the ground and cause you to lose control of your tractor.
11
Fig. 12

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents