Technical Specifications - HP ProLiant DL120 Quickspecs
Generation 7
Hide thumbs
Also See for ProLiant DL120:
- User manual (113 pages) ,
- Quickspecs (39 pages) ,
- Specifications (33 pages)
Table of Contents
Advertisement
QuickSpecs
Technical Specifications
System Unit
Dimensions (H x W x D)
(with bezel)
Weight
(approximate)
Input Requirements
(For 400W power supply)
BTU Rating
Power Specifications
Power Supply Output
(For 400W power supply)
System Inlet
Temperature
Relative Humidity
(non-condensing)
Altitude
DA - 14009 Worldwide — Version 21 — March 25, 2013
44.45 x 448.1 x 700.0 mm (1. 75" x 17.64" x 27.56")
Maximum
(four hard drives, power
supply, and processor
installed)
Minimum
(one hard drive, power
supply, and processor
installed)
Range Line Voltage
Rated Input Current
Rated Input Frequency
Rated Input Power
Maximum
To review typical system power ratings use the Power Advisor which is
available via the online tool located at URL:
efficient
or
www.hp.com/go/hppoweradvisor
Rated Steady-State Power 400 W (at 100 VAC),
Maximum Peak Power
Operating
Non-operating
Operating
Non-operating
Operating
HP ProLiant DL120 Generation 7 (G7)
26.23 lb
22.84 lb
90 - 132 VAC,
180 - 264 VAC
6 A (at 100 VAC),
3 A (at 200 VAC)
47 to 63 Hz
<570W (at 100 VAC)
570W (at 200 VAC)
1943 BTU/hr (at 100 VAC)
1943 BTU/hr (at 200 VAC)
www.hp.com/go/proliant-energy-
400 W (at 200 VAC)
430 W (at 100 VAC),
430 W (at 200 VAC)
10° to 35°C (50° to 95°F) at sea level with an
altitude derating of 1.0°C per every 305 m (1.8°F
per every 1000 ft) above sea level to a maximum
of 3050 m (10,000 ft), no direct sustained
sunlight. Maximum rate of change is 10°C/hr
(18°F/hr). The upper limit may be limited by the
type and number of options installed.
System performance may be reduced if operating
with a fan fault or above 30°C (86°F).
-30° to 65°C (-22° to 149°F). Maximum rate of
change is 20°C/hr (36°F/hr).
10 to 90% relative humidity (Rh), 28°C (82.4°F)
maximum wet bulb temperature, non-
condensing.
5 to 95% relative humidity (Rh), 38.7°C (101.7°F)
maximum wet bulb temperature, non-
condensing.
3050 m (10,000 ft). This value may be limited by
the type and number of options installed.
Maximum allowable altitude change rate is 457
Page 35
Advertisement
Table of Contents
