Set Up - Husqvarna 532RBS Operator's Manual

5. Set up

WARNING
• Assemble each part correctly. Wrong assembly
might cause an accident.
• If you cannot do the assembling yourself, consult
the shop where you bought this product.
■ ATTACHING THE SHOULDER STRAP (SE1)
1. Pass the ring of the shoulder strap through the
hook(A) and fix it by the bolt securely.
2. Set the hook(B) of each shoulder strap to the D-rings
on the frame.
SE1
■ ATTACHING THE LINER
1. Remove the bolt located on the joint of the outer
pipe. (SE2)
2. Match the groove of the liner with the threaded hole
and fix with screw securely. (SE2)
SE2
3. While rotating the flexible shaft located on the
opposite end from the liner, insert the flexible shaft
into the joint until it is tightly connected. (Note that it
is normal at this time for the flexible shaft not to
project from the liner.) (SE3)
SE3
4. To connect the clutch housing to the liner, lay the
liner out straight, align the flexible shaft with the
angular hole on the side of the clutch drum, and
(A) UPPER SIDE
(B) LOWER SIDE
(1) Hook (A)
(2) Bolt (M5x12)
(3) Hook (B)
(4) D-ring
(1) Bolt
(2) Joint
(3) Groove
(1) Flexible shaft
(2) Liner
(3) Clutch housing
insert the liner into the clutch housing, being careful
to make sure that the hole on the end of the liner is
facing directly upwards. When the hole reaches a
point directly below the stopper, you will hear a
clicking sound as the stopper moves into the hole to
fix the liner into place. (SE4)
SE4
• If you experience any difficulty in inserting the liner,
pull out the liner, rotate the flexible shaft slightly, and
try inserting it again.
• Once the liner has been inserted, pull on the liner to
make sure that the stopper is properly engaged.
IMPORTANT
After connecting the inner shaft to the shaft of the main
pipe, try to pull out the flexible shaft by hand to make
sure the flexible shaft does not come off.
■ ATTACHING THE THROTTLE CABLE
WARNING
After fitting the wire, check if the wire sleeve is
correctly fitted to the wire stopper. It is dangerous
if the wire sleeve is out of the wire stopper because
the engine speed will not decrease even if the
throttle lever is released.
• Align the throttle cable along with the liner and tie it
with band. (SE5)
SE5
1. Hook the cable and into the hole of the throttle lever.
And set the cable in the lever as shown in the picture.
(SE6)
(1) Clutch housing
(2) Stopper
(3) Angular hole
(4) Hole
(5) Liner
(1) Band
(2) Throttle cable
(3) Tie loosely
9