User Maintenance Instructions; Regular Cleaning - Kenmore 796.8099 Use & Care Manual And Installation Instructions

REGULAR CLEANING

wWARNING:
follow basic precautions, including the following:
• Unplug the dryer before cleaning to avoid the risk of electric shock. Failure to follow this warning can cause
serious injury, fire, electrical shock, or death.
• Never use harsh chemicals, abrasive cleaners, or solvents to clean the washer.
They will damage the finish.
Cleaning the Exterior
Proper care of your dryer can extend its life. The
outside of the machine can be cleaned with warm
water and a mild, nonabrasive household detergent.
Immediately wipe off any spills with a soft,
damp cloth.
IMPORTANT: Do not use methylated spirits, solvents,
or similar products.
Never use steel wool or abrasive cleansers; they can
damage the surface.
Cleaning the Interior
Wipe around the door opening and seal with a soft,
damp cloth to prevent lint and dust buildup that could
damage the door seal.
Clean the window with a soft cloth dampened with
warm water and a mild, nonabrasive household
detergent; then wipe dry.
The stainless steel drum can be cleaned with
a conventional stainless steel cleaner, used according
to the manufacturer's specifications. Never use steel
wool or abrasive cleansers; they can scratch or
damage the surface.
Cleaning Around and Under the Dryer
Vacuum lint and dust from around the dryer and
underneath it regularly. Vent ductwork should be
checked for lint buildup and cleaned at least once per
year. If any noticeable reduction in airflow or drying
performance occurs, immediately check ductwork for
obstructions and blockages.
maintaining Ductwork
Vent ductwork should be checked for lint buildup
and cleaned at least once per year. If any noticeable
reduction in airflow or drying performance occurs,
immediately check ductwork for obstructions and
blockages. Contact a qualified technician or service
provider.

USER MAINTENANCE INSTRUCTIONS

To reduce the risk of fire, electric shock, or injury to persons when using this appliance,
30
Cleaning the Lint Filter
Lint Filter
ALWAYS make sure the lint filter is clean before every cycle.
The Check Lint Filter Light on the control panel will blink before
every cycle to remind you.
NOTE: NEVER operate the dryer without the lint filter.
To remove lint between cycles:
1
Open the dryer door.
2 Pull the lint filter straight up. Then:
Roll any lint off the filter with your fingers.
3
Periodic thorough cleaning:
Some fabric softeners can build up on the lint filter over time.
This buildup can restrict the airflow through the filter reducing
dryer efficiency and lengthening dry times. If the filter looks dark
or dirty when held up to the light, follow these steps to clean:
1
Use hot soapy water and a stiff brush to clean the filter.
2 Make sure the filter is completely dry before reinstalling
and using the dryer.
NOTE: NEVER operate the dryer with a wet lint filter.