Agitator Assembly - Kenmore 116.22151C Owner's Manual

PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l'aspirateur pour l'utiliser correctement et en
toute sécurité. Lire cette section avant de l'utiliser.
POWER-MATE ®
Pièce Nº aux Nº Au
Etats-Unis Canada
Courroie 20-5279 20-40111
Porte-cordon
Réglage de
la hauteur
Protecteur de
de poils
surcharge (Bouton
de remise en marche)
Porte - fiche
Porte - cordon
Cordon
Power-Mate ®
Tube
Porte-cordon
Tube
Courroie
Nettoyeur de
bords (Non ilustré)
4
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
Power-Mate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.

AGITATOR ASSEMBLY

End
Cap
Brush Unit
End
Cap
Belt Groove
TO REPLACE BELT
1. Install new
belt in belt
groove on the
Belt
agitator
assembly, then
Motor Shaft
over the motor
Belt
shaft. Be sure
Guard
belt is under
the belt guard.
NOTE: See PARTS AND FEATURES for
Belt number.
2. Insert
both support
tabs into the
base slots.
Then snap
end caps into
Front
Support
place.
Tab
3. Line up
tabs on front
of base with
slots inside
the front
Cover
cover.
Front
Slot
Base Tab
4. Tilt cover to
back. Press
cover firmly
until rear tabs
snap into
place.
Rear Base Tab
5. Turn Power-Mate ® over. Replace the
cover screws and lower the pile height
adjustment rollers into place.
17