Image Colors Are Not Right - Epson EB-485Wi User Manual

Problem Solving
Check
Is the image still being enlarged by E-Zoom?
Is the display position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Is the correct resolution selected?
(Only when projecting computer images)
Did you adjust the image position after performing Adjust Zoom or
Keystone?

Image colors are not right

Check
Do the input signal settings match the signals from the connected
device?
Is the image Brightness adjusted correctly?
Are the cables connected correctly?
g
Is the contrast adjusted correctly?
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
(Only when projecting analog RGB signals input from the Computer1 or Computer2 port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.99
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.150
s Computer's documentation
Perform Image Shift to adjust the image position after performing Adjust Zoom or Keystone.
s "Adjusting the Position of the Image (Image Shift)"
Change the following settings according to the signal for the connected equipment.
• When the image is from a device connected to the Computer1 or Computer2 port.
s Signal - Input Signal p.99
• When the image is from a device connected to the Video or S-Video port.
s Signal - Video Signal p.99
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.98
Check that all the cables required for projection are securely connected.
s "Connecting Equipment" p.26
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.98
Remedy
p.69
] button on the control panel to adjust the position.
p.48
Remedy
127