Table of Contents
Advertisement
When the washing cycle begins, the
«washing» light is on.
3.7. Action during a programme
3.7.1. Adding of laundry
Press the Start/Pause pushbutton : the corresponding
light flashes as long as the programme is paused. You
will then hear a double "click" in the locking device
when the cover opens. Press the same pushbutton
again to resume the programme.
For reasons of safety, you cannot open the cover if the
temperature of the washing water is too high.
3.7.2. Modifying the current programme
Before modifying the current programme, you must put
the washing machine to pause by pressing on the
«Start/Pause» pushbutton. If it is impossible to make
the modification, the corresponding light flashes for few
seconds. If you decide to change the programme in any
case, you will need to cancel the current programme
(see below).
3.7.3. Cancelling the programme
If you want to cancel a programme, turn the programme
selector knob to the «off» position of the programme
selector.
You can then select a new programme after cancelling
the previous one.
3.8. End of program
The washing machine stops automatically. You will
hear a double "click" in the locking device when the
cover opens. The cycle end light goes on.
If you choose the rinse hold position on the spin speed
variator, the rinse hold light* illuminates to inform you
that water has to be drained before you can open the
cover. To terminate the cycle, you can then spin the
washing by choosing the spin program or drain it by
choosing the drain program.
Turn the program selector knob to the "Off" position.
Take out the laundry.
Pull out the power supply plug and close the water sup-
ply tap.
Note: we recommend that you should leave the cover
and the drum open after use to air the washing drum.
*depending to the model
6
Advertisement
Table of Contents
