Installation; Unpacking; Before Installing The Cabinet; Cleaning - Zanussi ZV280 Instruction Booklet

Installation

Unpacking

Unpack the cabinet and check that it is in good
condition and free of any transport damage. Notify
the dealer immediately of any damage. Hand the
packaging over for recycling. For more information,
contact your local city office or the dealer.
Do not allow children to play with the
packaging. The plastic film can cause
suffocation.

Before installing the cabinet

Affix the supplied plastic peaces at the rear of the
cabinet.
It is possible to have the door decorated with a
panel.
The panel and the frames for assembling can be
ordered separately from Your dealer.

Cleaning

Wash the inside of the cabinet using lukewarm
water, a mild washing-up detergent and a soft cloth.

Installing the cabinet

To otain the best performance from the cabinet, ensure
:
·
the cabinet is placed in a dry, cool place and
is not exposed to direct sunlight.
·
the cabinet is not placed close to a source of
heat, e.g. a cooker or dishwasher.
·
the room in which the cabinet is placed
has a temperature of +16C to +32C.
·
the cabinet is level.The cabinet should not lean
against any wall. If necessary adjust the
feet using the supplied adjustment spanner.
·
there is good air circulation around the cabinet
and that the air channels below and behind
the cabinet are not blocked. The ventilation
space above the cabinet and any
grocery/top cabinet must be at least 200 cm@.
The ventilation space can either be
a) directly above the cabinet, or
b) behind and above the top cabinet. In this case,
the space behind the cabinet must be at least
50 mm deep.
If the cabinet is placed in a corner and the side with
the hinges faces the wall, the distance between the
wall and the cabinet must be at least 10 mm to allow
the door to open enough so that the shelves can be
removed.
a)
20
GB
b)
50mm
Zanussi 8181497-01/0