Table of Contents
Advertisement
Mounting of door panels
The door can be decorated with panels. If youcabinet
is not equipped with door frames, they can be
orderd seperately.
1. Remove the handel and the frame of the side
where the handle is fitted.
2 Loosen the screws of the other frames.
3 Adjust the panel and screw it in place.
4. Mount the removed frame and the handle.
Measurements fo the door panels:
Height
(mm)
ZV280P-1
1436
ZV320P-1
1636
Door Reversal
)
1. Close the cabinet and remove the plug from the
electrical socket.
2. Remove the ventilation grille. There is a part on
the grille that can be removed. Reposition it and put
it on the other side.
3. Put the cabinet on a wooden board when it is laid
down. Later, when raising the cabinet, it will be
easier to grip under the cabinet thanks to the board.
4. On the upper part of the cabinet. Move the hinge
pin and cover washer.
5. On the lower part of the cabinet. Unscrew the
hinge. Move the hinge pin and plastic cover. Secure
the hinge on the other side.
6. Raise the cabinet and replace the ventilation grille.
7. Unscrew the handle. Carefully press in the plastic
plugs on the opposite side using a drift. Secure the
handle in the plug holes. Then press the supplied
plastic plugs into the holes to which the handle was
previously fitted.
8. Put the cabinet in position. Check that it stands
straight. See the section "Positioning the cabinet".
Electrical connection
Connect the cabinet to a grounded electrical outlet.
Voltage: 230 V.
Fuse: 10 A.
Refer to the rating plate on the left inside the
cabinet.
Width
Depth
(mm)
(mm)
584
4max
584
4max
1
2
3
4
5
7
21
Zanussi 818 14 97-02/8
Advertisement
Table of Contents
