Procedure - Yamaha F6D Ower's Manual

Maintenance
the outboard motor on its side (not up-
right), put it on a cushion after draining
the engine oil.
Do not place the outboard motor on its
G
side before the cooling water has
drained from it completely, otherwise
water may enter the cylinder through the
exhaust port and cause engine trouble.
Store the outboard motor in a dry, well-
G
ventilated place, not in direct sunlight.
EMU28301

Procedure

EMU28371
Flushing in a test tank
1. Wash the outboard motor body using
fresh water. For further information, see
page 51.
2. Fill the fuel tank with fresh fuel and add
one ounce of "Yamaha Fuel Conditioner
and Stabilizer" (Part No. LUB-FUELC-12-
00) to each gallon of fuel.
NOTE:
The use of "Yamaha Fuel Conditioner and
Stabilizer" eliminates the need to drain the
fuel system. Consult your Yamaha dealer or
other qualified mechanic if the fuel system is
to be drained instead.
3. Remove the engine top cowling and si-
lencer cover.
4. Install the outboard motor on the test
tank.
48
1. Water surface
2. Lowest water level
5. Fill the tank with fresh water to above the
level of the anti-cavitation plate.
ECM00300
CAUTION:
Do not run the engine without supplying it
with cooling water. Either the engine water
pump will be damaged or the engine will
be damaged from overheating. Before
starting the engine, be sure to supply wa-
ter to the cooling water passages.
ECM00290
CAUTION:
If the fresh water level is below the level of
the anti-cavitation plate, or if the water
supply is insufficient, engine seizure may
occur.
6. Cooling system flushing is essential to
prevent the cooling system from clogging
up with salt, sand, or dirt. In addition, fog-
ging of the engine is mandatory to pre-
vent excessive engine damage due to
rust. Perform the flushing and fogging at
the same time.
EWM00090
WARNING
Do not touch or remove electrical parts
G
when starting or during operation.
1
2
ZMU02051