Advertisement
Advertisement
Table of Contents
Related Manuals for Yamaha EQ-1100
Summary of Contents for Yamaha EQ-1100
- Page 6 WARNING ENGLISH TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR • Thank you for purchasing the YAMAHA EQ-1100/U graphic equalizer. MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK DO CAUTION: READ THIS BEFORE OPERATING NOT USE THIS (POLARIZED) PLUG WITH AN YOUR UNIT.
- Page 7 The ACCESSORY jacks are provided on some of 3. Channel indicators TAPE PB jacks to the tape deck's LINE OUT terminal, and Yamaha's newest amplifiers and receivers. During equalizer display: the REC OUT jacks to the tape deck's LINE IN jacks.
- Page 8 6. Input Indicators • 4 kHz band 11. Input select buttons The source selected by the input select buttons is The human ear is also highly sensitive in this range. Mainly Press one of these buttons to select the source to be indicated.
-
Page 9: Remote Control Transmitter
■ REMOTE CONTROL TRANSMITTER 16. PINK NOISE button REMOTE CONTROL TRANSMITTER Pink noise, which is emitted by a built-in generator, is a (See Fig. 5) random noise signal which is distributed at an even level at With the supplied remote control transmitter, most all frequencies, and when monitored through the supplied 22. -
Page 10: Before Operation
■ AUTO-LEVELING FUNCTION Changing the battery (See Fig. 9.) BEFORE OPERATION © Remove the cover. If the spectrum level becomes too high or too low due to ■ DISPLAY MODES the influence of the input signal level, the auto-leveling (2) Insert battery (size "AA", R06), or equivalent making function adjusts the spectrum display level in three steps sure that the positive and negative poles are facing in (0 dB, -6 dB, -12 dB) so that the spectrum is always at the... -
Page 11: Auto Equalization
■ MEMORY FACILITY 7. Press the AUTO ROOM EQ button. OPERATIONS The ROOM EQ indicator will light, and the auto equalization operation for the listening room The unit is provided with four user memories that can be characteristic for the left channel starts. After the left ■... - Page 12 ■ MANUAL EQUALIZATION ■ HOW TO RECALL PRESET MEMORY ■ HOW TO SUPERIMPOSE EQUALIZER CURVES 1. Set the EQ CURVE DISPLAY button to ON. Press the preset memory button of the memory to be The equalizer levels will be displayed with dots. recalled.
-
Page 13: Troubleshooting
Before assuming that your amplifier or receiver is faulty, check by following troubleshooting list which details corrective action which you can take yourself. If the fault persists, or is not ;ntioned in the list, turn off and disconnect the unit immediately, and get in touch with your nearest Yamaha dealer:...