Compatible Outdoor Sensors; Dashes Shown For Outdoor Temperature/Humidity; Inaccurate Outdoor Temperature/Humidity; Outdoor Temperature/Humidity Is Stuck Or Ofl - La Crosse Technology C84612 Information

 2-C batteries power the thermo-hygro sensor
 2-AA batteries for the rain sensor
 We recommend Alkaline
 100% solar-powered (built-in power cell, no batteries necessary) for wind sensor
 3-C batteries for the weather station

Compatible outdoor sensors

 TX59UN-1-IT Thermo-hygro
 TX63U-IT Wind
 TX58UN-IT Rain
 The above 915MHz sensors will read to this weather station.

Dashes shown for outdoor temperature/humidity

 Dashes means the connection is lost between the weather station and the outdoor sensor.

Batteries often resolve the connection.

Distance/Resistance
 Reorientation of the weather station 90 degrees towards the thermo-hygro sensor may provide better
reception by the antenna.
 Remove the batteries from the thermo-hygro sensor for two minutes. Replace the batteries in the
thermo-hygro sensor and after 5 minutes hold the UP ARROW on the weather station until it beeps.
 Wait 10 minutes. If the weather station does not receive a reading from all the sensors, please try the
factory reset.
 Try the
quick connect

Inaccurate outdoor temperature/humidity

 The thermo-hygro sensor reads the environment. When the sensor reads high during the day but not
at night it is a mounting
 Side-by-side test: Bring the thermo-hygro sensor in the house and place it next to the weather
station for 2 hours.
 Compare indoor and outdoor temperature. The temperatures should be within 4 degrees to be within
tolerance. The humidity should be within 14% to be within tolerance.
 If the sensor reads correctly when next to the weather station then try a different location outside.
 Look for heat sources such as sunlight, door or window frames, or reflected heat.

Outdoor temperature/humidity is stuck or OFL

 Check batteries. Overpowered or underpowered batteries can cause this reading.
 Replace outdoor sensor.

Intermittent outdoor temperature/humidity

 RF (radio frequency) communication may come and go occasionally. This can be normal in some
environments (e.g. moister climates). If sensor signal is lost, please wait 2-4 hours for the signal to
reconnect on its own.
 Move the remote sensors to a location closer to the weather station.
 Indoor distance test: Please complete the
apart and inside to establish a strong connection.
 If there is a reading in the outdoor temperature area after 15 minutes, move the sensor to another
room with one wall between the sensor and the weather station. Observe to see if the remote
readings remain on consistently for 1 hour.
 If the remote reading remains on while in the house then it is likely a
 Move the sensor to different locations outside to find a location where the remote readings will hold.

Distance/Resistance
 Check Batteries.
La Crosse Technology, Ltd.
batteries for the sensors.
can cause loss of connection between the sensor and the weather station.
or complete a factory
problem.
can cause loss of sensor signal.
restart.
factory restart with sensors and weather station 5-10 feet
distance/resistance issue.
Page 4