Connect The Speaker Cables - Panasonic SC-HT1500 Operating Instructions Manual

3

Connect the speaker cables.

≥Twist off the vinyl ends of the speaker cables.
4
Adjust the speaker height.
≥Check the screws you tightened in procedures 1-3 and 2 -3 if the pipe and speaker are loose (
1 Loosen the attached mounting plate screw
until the attached speaker is slightly loose
and adjustable.
Be careful not to loosen the screw too much
or the speaker may detach and fall.
Phillips-head screwdriver
∫ Front and surround speaker height
(Assembled diagram)
Speaker
Pipe
1122.5 mm 715.5 mm
Base
5
Fasten the speaker cable.
≥Using the same polyfoam as done in procedure 2 will assist you in safely and securely fastening the speaker cables.
∫ For rear side of speaker
Press the speaker
cable into the
groove.
∫ For rear side of base
1 Press the speaker cable and thread
between the hooks.
r:Copper
Push!
s:Silver
You can adjust within this
range.
Stopper screw
Do not remove.
If there is any excess speaker
cable, thread the speaker
cable from the opening near
the top of the pipe while lightly
pulling the speaker cable from
the bottom of the base.
Rear side of speaker
page 6).
2 With one hand on the base, and the other
holding the speaker, adjust the height of
the speaker up and down.
3 Tighten the mounting plate screw
securely.
Stopper screw
Screw to stop mounting plate from moving or
sliding below this point.
For your reference
You can enjoy good acoustics by
adjusting the height of the front and
surround speakers to the height of
the television so the center position
of both are approximately the same.
2 Fit the speaker cable into the base
cover groove as far as possible.
Cable
RQT7621
7