Table of Contents
Advertisement
Optional Answering Machine Settings
Optional Answering Machine Settings
Setting ICM time
Incoming messages (ICMs) are the
messages which callers leave for you
on the built-in answering machine.
The answering machine is set at the
factory to allow each caller a
maximum of 4 minutes to leave a
message. If desired, you can change
this setting to 15, 30, or 60 seconds.
1
Press these keys:
FUNCTION
ICM RECORD TIME
2
Press a numeric key to select the
desired ICM recording time:
1: 15 seconds
2: 30 seconds
3: 60 seconds
4: 4 minutes
3
Press the STOP key.
STOP
30
0
Press
3 times
1
2
3
4
Fax reception on A.M. failure
If the memory for recording incoming
messages becomes full while you are
out, the answering machine will no
longer be able to record messages.
The ON A.M. FAILURE setting is
used to choose the response of the
machine to incoming calls when this
happens:
Automatic fax reception NO: The
UX-485 will answer after 20 rings,
after which it will wait to receive a
remote command. Most callers will
hang up before it answers;
however, when you call the UX-485
from a remote location, you can
wait until it answers, listen to your
messages, and then erase them
(see Remote Operations in this
chapter).
Automatic fax reception YES: The
reception mode will switch to FAX
mode, allowing the UX-485 to
continue to receive faxes
automatically. With this setting, you
can still use the remote commands
to listen to your messages and
erase the message memory (see
Remote Operations in this chapter).
Automatic fax reception is set to NO
at the factory before shipping. If you
want to set it to YES, press the panel
keys as follows:
Advertisement
Table of Contents
