Displays And Controls; Front Panel - Pioneer VSA-E07 Operating Instruction

Displays and Controls

Front Panel

All the controls on the front panel are explained and/or referenced here. To open the front panel push gently on
the lower third of the panel.
1 2 3 4 5 6
STANDBY/ON
STANDBY
THX CINEMA
OFF ON
S-VIDEO
PHONES
¡
1 Main power (_ ON/ — OFF) button
If the button is OFF (—), the power of the
amplifier is shut off and the STANDBY/ON button
on the amplifier or the remote control do not
function. Pressing the button again will turn the
amplifier ON (_) and the amplifier enters the
standby mode. In the standby mode, you can
turn on the amplifier using the STANDBY/ON
button on the amplifier or the remote control.
2
STANDBY/ON button
Press to switch the amplifier ON or into
STANDBY mode.
3 STANDBY indicator
Lights when the amplifier is in STANDBY mode.
(Please note that this amplifier consumes a small
amount of power (1.0 W) during the standby
mode.)
4 DSP MODE button (See p.41-42)
Press repeatedly to select a DSP sound mode
(HALL 1, HALL 2, JAZZ, DANCE, THEATER 1, or
THEATER 2). Use these modes to produce
surround sound from standard (two channel)
stereo sources and create different listening
environments.
16
En
AUDIO / VIDEO MULTI - CHANNEL AMPLIFIER
DSP
MODE STEREO
/DTS
ADVANCED STANDARD
MPEG
VIDEO VCR 1/DVR VCR 2
~ ! @ # $ %
EXTERNAL
VIDEO INPUT
DECODER IN DIRECT LOUDNESS MIDNIGHT
VIDEO L AUDIO R
SPEAKERS - BASS +
+ _ )
7 8 9 0
MD/TAPE 1/ LINE/
DVD /LD TV/SAT CD CD-R TUNER PHONO
EFFECT/
DIGITAL SIGNAL CHANNEL
– LEVEL +
NR SELECT SELECT
LEVEL CONTROL
TAPE 2
- TREBLE + INPUT ATT MONITOR
5 –CHANNEL EQUAL POWER OUTPUT
( * &
5 STEREO button (See p.41-42)
Press to select the STEREO sound mode. In this
mode, sound comes from the front (left and right)
speakers only.
2
6
/DTS buttons (See p.40,42 & 68-70)
THX CINEMA : Press to select the HOME THX
CINEMA mode when listening to Dolby Digital,
Dolby Pro Logic or DTS a variety of other
sources.
ADVANCED THEATER : Press to select one of
the four Advanced Theater modes.
STANDARD (
MPEG
the standard mode and MPEG mode.
7 Display (See p.18)
8 Remote sensor
Point the remote control toward the remote
sensor to operate the amplifier.
9 Source indicators
Shows the source currently selected.
0 FL DIMMER button (See p.49)
Use to adjust the brightness of the main display.
- =
INPUT
SELECTOR
FL
DIMMER
MASTER
VOLUME
MIN MAX
^
) : Press repeatedly to select