Connections - Panasonic TH-37PR10R Operating Instructions Manual

Connections

– AC cord fi xing
Note:
Make sure that the AC cord is locked
on both the left and right sides.
– Cable fi xing bands Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
1
SLOT1
Optional Terminal
Board Insert Slot
(covered)
8
1
Plug the AC cord into
1
the display unit.
Plug the AC cord until
it clicks.
2
Fix the AC cord with
2
the clamper which is
attached to the unit.
To secure cables connected to Terminals, wrap the cable fi xing band around them
then pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
2
SLOT2
Optional Terminal Optional Terminal
Board Insert Slot Board Insert Slot
(covered) (covered)
AC cord connection (see page 11)
Close
Push until
t h e h o o k
clicks.
Open
2. Pull off.
1. Keep the
knob pressed.
To tighten:
Pull
SLOT3
PC
From EXTERNAL
monitor terminal
on Computer (see
page 9)
Unplug the AC cord
Unplug the AC cord pressing
the two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet fi rst.
To loosen:
Push the catch
Pull
AUDIO
IN SERIAL
From SERIAL
Terminal
on Computer
(see page 10)