Table of Contents
Advertisement
10.4. Fine Convergence Adjustment
10.4.1. Green Convergence Adjustment
1. Select the "G-LINE CURSOR" mode by pushing "TV/AV"
button on the remote control
2. Use the Position Buttons to move the cursor to the point
where you wish to change the data (adjustment lines). Then
use the "MULTI PIP" to change from "G-LINE CURSOR" to
"G-LINE DATA".
3. Use the Position Buttons to adjust each point (line) so that
the Green Crosshatch Pattern is aligned with the vertical
and horizontal lines of the Convergence Adjustment Sheet.
4. Push the "MULTI PIP" and switch from "G-LINE DATA" to
"G-LINE CURSOR".
5. Repeat step 21~23 to adjust the vertical lines (13) and the
horizontal lines (9).
6. Select the "G-EASY CURSOR" mode by pushing "TV/AV"
button on the remote control.
7. Use the Position Buttons to move the cursor to the point
where you wish to change the data (adjustment point). Then
use the "MULTI PIP" to change from "G-EASY CURSOR"
to "G-EASY DATA".
8. Use the Position Buttons to adjust each point so that the
Green Crosshatch Pattern is aligned with the vertical and
horizontal lines of the Convergence Adjustment Sheet.
9. Push the "MULTI PIP" and with from "G-EASY DATA" to
"G-EASY CURSOR".
10. Repeat step 7~9 to adjust the 9 adjustment points.
11. Select the "G-POINT CURSOR" mode by pushing "TV/AV"
button on the remote control.
12. Use the Position Buttons to move the cursor to the point
where you wish to change the data (adjustment lines). Then
use the "MULTI PIP" to change from "G-LINE CURSOR" to
"G-LINE DATA".
13. Use the Position Buttons to adjust each point so that the
Green Crosshatch Pattern is aligned with the vertical and
horizontal lines of the Convergence Adjustment Sheet.
14. Push the "MULTI PIP" and switch from "G-POINT DATA" to
"G-POINT CURSOR".
15. Repeat step 12-14 to adjust all of adjustment points.
37
TX-47P500HM / TX-47P500HQ / TX-47P500HZ / TX-47P500X
Advertisement
Table of Contents
