Table of Contents
Advertisement
INSTALLATION
INSTRUCTIONS
R@mOY@
M _¸_°_f_
_ _(_'
NOTE: To avoid possible damage to the work surface, cover the
work surface.
1. Remove any remaining contents from the microwave oven
cavity.
2. Remove the 2 screws that attach the mounting plate to the
back of the microwave oven, then remove mounting plate and
set aside.
,
\
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0
-_
DO
o o o^o
o o o o
o o o o o o o o o o o o^o o o o
DD
A
B
A. Mounting plate
B. Back of microwave
oven
3. Reattach the 2 screws.
4. Tape the microwave oven door closed so that door does not
swing open while the microwave oven is being handled.
NOTE: To avoid damage to the microwave oven, do not grip or
use the door or door handle while the microwave oven is being
handled.
The microwave oven is set for recirculation installation. For wall or
roof venting, changes must be made to the venting system.
NOTE: Skip this section if you are using recirculation installation.
Keep the damper assembly in case the venting method is
changed, or the microwave oven is reinstalled in another location
where wall or roof venting may be used.
Wall Venting Installation Only
1. Remove screw attaching damper plate to top of microwave
oven exterior. Lift up damper plate.
2.
A
B
A. Screw
B. Damper plate
Remove the blower motor screw from the back of the
microwave oven, then lift out blower motor.
A
3.
S
.................................
A. Blower motor
B. Blower motor screw
Rotate blower motor 180 ° so that exhaust ports face the back
of microwave oven, and lower blower motor back into the
microwave oven.
A. Exhaust port
4
Hide quick links:
Advertisement
Table of Contents
