Make Gas Connection; Electronic Ignition System; Complete Installation; Important - KitchenAid KGRS505XWH02 Installation Instructions Manual

30" (76.2 cm) double oven gas ranges
Table of Contents

Advertisement

Available languages

Available languages

To Convert Surface
Burners
1. If the burner grates are installed, remove them.
2. Remove the burner caps.
3. Using a Phillips or Torx®screwdriver, remove the burner base.
:2
......................................................
L
4,
A. Burner cap
B. Gas tube opening
C. Burner base screws
D. Burner base
Apply masking tape to the end of a 9_32" ( 7.0 mm) nut driver to
help hold the Natural gas orifice spud in the nut driver while
changing it. Press nut driver down onto the Natural gas orifice
spud and remove by turning it counterclockwise
and lifting
out. Set the Natural gas orifice spud aside.
A. Natural
gas orifice
spud
Use the following chart for correct LP gas orifice spud for each
burner. Refer to the model/serial
rating plate behind the control
panel for proper sizing of LP gas orifice spuds for each burner
location.
LP Gas Orifice Spud Chart
Burner Rating
Color
Number
4,000 BTU
Blue
64L
7,000 BTU
Black
81 L
9,100 BTU
Green
97L
14,000 BTU
Red
114L
5. Replace the Natural gas orifice spud with the correct LP gas
orifice spud. See the "LP Gas Orifice Spud Chart."
6. Replace burner base and hand tighten the screws.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
9. Place Natural gas orifice spuds in plastic parts bag for future
use and keep with literature package.
10. Replace burner grates.
11. Complete installation. See "Make Gas Connection"
and
Electronic Ignition System" sections.
Checking for proper cooktop burner flame is very important.
The small inner cone should have a very distinct blue flame
1_,,to 1/2" long. The outer cone is not as distinct as the inner
cone. LP gas flames have a slightly yellow tip.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti=tip bracket to rear range foot.
Reconnect
the anti=tip bracket,
if the range is moved.
Failure to follow these instructions can result in death
or serious
burns to children
and adults.
1. Turn manual shutoff valve to the closed position.
B
A__
........................
C
A. To range
B. Shutoff valve (closed position)
C. Gas supply line
2. Unplug range or disconnect
power.
15

Advertisement

Table of Contents
loading

Table of Contents