Charging Battery Pack - Hitachi MpegCam MP-EG10W Instruction Manual

Chapter 2 Set-up ___________________

Charging Battery Pack

The battery pack is the portable power supply of the MP-EG10W. Charge before use.
When the battery remaining level indicator
the battery pack" instruction (on page 21 ). A fully charged battery pack powers the MP-EG10W for about 40 minutes.
Battery pack AC adapter/charger
(MP-BP1A)
Plug the AC adapter/charger into
1
an AC outlet.
The red POWER indicator will light.
POWER indicator
2
Attach the battery pack.
The green CHARGE indicator will light and
charging will start. Continue charging the battery
pack until the indicator goes out. Charging will
be finished in about 100 minutes. After charging
is finished, unplug the AC adapter/charger from
the AC outlet, and then remove the battery pack
from the AC adapter/charger.
Skillful use of battery pack
See "Tips on Battery Pack" on page 106.
E20
flashes white, you need to re-charge the battery pack. See "Removing
Caution: Be sure to use the specified MP-
(MP-AC1A)
AC1A AC adapter/charger to charge
the battery pack.
If you use AC adapter/chargers other
than the MP-AC1A, heat generation,
damage, fire, leakage of liquid, etc.
could result.
CHARGE indicator
Note: Charging is not possible if the DC power
cord is plugged into the AC adapter/charger.