Table of Contents
Advertisement
Available languages
Available languages
Leveling
the
Range
Models
Equipped
with
Leveling
Device
Level the range after installation
in the cutout
opening,
1.
Open the range drawer. The leveling screws control
the height of the rear leg.
2.
Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level on
the countertop (Figure 12).
a.To adjust the front legs, use a wrench on the
leg base and turn clockwise to lower or
counterclockwise
to raise.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise
to lower or clockwise to raise.
3.
Check if the range is level by installing an oven
rack in the center of the oven and placing a level
on the rack (Figure 13).
4.
Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5.
if the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1.
Install Burner Caps and Triple burner head
This cooktop is equipped with sealed burners.
A.
Unpack the burner grates.
B.
Regular Burners: Burner heads and burner caps
are already on the surface. Remove all tapes
from burner caps and verify if they are correctly
place on the burner heads (see Figure 14).
Burner Cap
Gas Opening
Burner Head
Leveling
Font
Leveling
Leg
LOWER
RAISE
Figure 12
Electrode
Figure 14
C. Triple Burner (if equipped):
Remove all tapes
from burner cap. Remove the burner cap and
head. Remove and discard the packaging
material. Replace head and cap on the triple
burner. Be careful
not to damage
the
electrode
while
placing the head over the
orifice.
Make sure electrode fits correctly into
slot in burner head (see Figure 15).
D. Be sure that all the burner caps and the triple
burner head are correctly placed BEFOREusing
your cooktop.
NOTE: There are no burner adjustments necessary on
this cooktop.
2. Turn on Electrical
Power and Open Main Shutoff
Gas Valve
Figure 13
I0
Advertisement
Table of Contents
