Cisco WRP400 Regulatory Compliance And Safety Information Manual page 27

Other Country Restrictions
Other countries have the following additional requirements or restrictions than those listed in Table 2.
France—For 2.4 GHz, the output power is restricted to 10 mW EIRP when the product is used outdoors
in the band 2454 – 2483,5 MHz. There are no restrictions when used indoors or when used in other parts
of the 2.4-GHz band.
Pour la bande 2.4-GHz, la puissance est limitée à 10 mW en p.i.r.e. pour les équipements utilisés en
extérieur dans la bande band 2454 – 2483,5 MHz.. Il n'y a pas de restrictions pour des utilisations en
intérieur ou dans d'autres parties de la bande 2,4 GHz. Consultez http://www.arcep.fr/ pour de plus
amples détails.
Italy—This product meets the National Radio Interface and the requirements specified in the National
Frequency Allocation Table for Italy. Unless this wireless LAN product is operating within the
boundaries of the owner's property, its use requires a "general authorization". Please check
http://www.comunicazioni.it/it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale
di ripartizione delle frequenze in Italia. Se non viene installato all'interno del proprio fondo, l'utilizzo
di prodotti Wireless LAN richiede una "Autorizzazione Generale". Consultare
http://www.comunicazioni.it/it/ per maggiori dettagli.
Latvia—The outdoor usage of the 2.4 GHz band requires an authorization from the Electronic
Communications Office. Please check http://www.esd.lv for more details.
2,4 GHz frekvencu joslas izmantošanai arpus telpam nepieciešama atlauja no Elektronisko sakaru
direkcijas. Vairak informacijas: http://www.esd.lv.
The regulatory limits for maximum output power are specified in Equivalent Isotropic Radiated Power
Note
(EIRP). The EIRP level of a device can be calculated by adding the gain of the antenna used (specified
in dBi) to the output power available at the connector (specified in dBm).
Radio
This section describes radio compliance conditions for the Cisco SPA100 Series Analog Telephone
Adapters.
The Part 15 radio device operates on a non-interference basis with other devices operating at this
Caution
frequency when using the integrated antennas. Any changes or modification to the product not expressly
approved by Cisco could void the user's authority to operate this device.
This device operates in the 5150-5250MHz and 5470-5725MHz bands and is therefore restricted to
Caution
indoor operation only (per FCC guidance). The use of this system outdoors is not in compliance with
FCC regulations or guidelines. 

Please contact your Cisco salesperson for additional details.
Regulatory Compliance and Safety Information for the Cisco WRP400 Wireless-G Broadband Router with 2 Phone Ports
78-20472-01
Radio
27