Electrical Requirements - GE JVM1600 Series Installation Instructions Manual

Installation Instructions
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-i)rong grounded outlet.
The installer u/list i)erform a grouud coutiuuitv check
on the power outlet box before beginning the
installation to insm'e that the outlet box is properly
grotmded. If not properly grotmded, or if the outlet
box does not meet electrical requirements noted
(under EI,ECTRICAI, REQUIREMENTS), a qualified
electrician should be employed to correct any
deficiencies.
CAUTION:
For personal safety, remove
house fuse or open circuit
breaker before beghuth_g
installation to avoid severe
or fatal shock h_jury.
CAUTION:
For personal safety, the mounting
surface must be capable of supporting the cabinet load,
in addition to the added weight of this 63-85 pound
product, plus additional oven loads of up to 50 pounds
or a total weight of 113-135 pounds.
CAUTION:
For personal safety, tiffs product
cmmot be installed in cabinet axrmlgements such as m_
islm_d or a pmthlsuia. It must be momlted to BOTH
a top cabinet AND a wall.
NOTE: For easier installation mid personal safety, it is
recommended that two people instaJl tiffs product.
IMPORTANT--PLFASE READ CAREFULLY. FOR
PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED TO AVOID SEVERE OR
FATAL SHOCK.
Insureproper
groundexists
before use
The power cord of this
applimlce is equipped with
a three-prong (grounding)
plug which mates with
a stmldaacd three-prong
(grounding) wall receptacle
to mhthuize the possibility
of electric shock hazard
from tiffs applimlce.
You should have the wail receptacle and circuit checked
by a qualified electrician to make sure the receptacle is
properly grounded.
Where a staaldaaxi two-prong wall receptacle is
encountered, it is very hnportaut to have it replaced
with a properly grounded three-prong wall receptacle,
installed by a qualified electriciml.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT,
DI?_'ORM OR REMOVE ANY OF TFIE PRONGS
FROM THE POWER CORD. DO NOT USE WITH
AN ILXTENSION CORD.
ELECTRICAL
REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14 amps and
1.60 kilowatts. This product must be connected to a
supi)ly circuit of the proper \_ltage and fl'equency.
_'_]re size must contimn to the requirements of the
National Electrical Code or the pre\_filing local code
tot this kilowatt rating. The power supply cord and
plug should be brought to a separam 15 to 20 ampere
branch circuit single grounded outlet. The outlet box
should be located in the cabinet above the oven. The
outlet box and suI)ply circuit should be installed by
a qualified electrician and conflmn to the National
Electrical Code or the prevailing local code.
3