GE PB909SP3SS Installation Instructions

[
• All ranges can tip.
• BURNS or other SERIOUS
INJURIES can result.
• INSTALL and CHECK the
ANTI-TIP bracket following
the instructions supplied
with the bracket.
STEP 1 LOCATE THE BRACKET
IMPORTANT: Determine the final location of the range
before attempting to install the bracket.
a. Place the bracket on the floor with the back edge against
the rear wall. If the range does not reach the rear wall,
align the back edge of the bracket with the rear panel of
the range in its final location.
RearWall
Adjacent cabinet or
final locationof range
side panel
LocA
LocC
LecB
Two screws must enter floor
or wall at Lec A, BerC.
ir bracket does not touch the rear wall, gou MUST
screw bracket to FLOOR as described in Step 2.
b. Position the side of the bracket against either the left or
right cabinet. If there is no adjacent cabinet, align the
edge of the bracket with the side panel of the range in
its final location. If the countertop overhangs the
cabinet, offset the bracket from the cabinet bg the
amount of overhang.
c. Mark the location for the pair of holes to be used (see
illustration above).
NOTE: For FLOOR installation use either Loc A or B. For
REARWALL installation use Loc C.
31-10671 ]
04-08 JR
To reduce the RISKOF TIPPING the range, the range must be
secured bg a properly installed ANTI-TIP BRACKET.
Secure the bracket with the screws provided.
NOTE: The installation of the ANTI-TIP bracket must meet all
local codes for securing the appliance.
If gou did not receive an anti-tip bracket with gour purchase,
call 1-800-626-8774 to receive one at no cost.
In Canada, call 1-800-561-3344,
For installation instructions of the bracket, visit: GEAppliances.com.
In Canada, GEAppliances.ca.
STEP 2 SECURE THE BRACKET
The bracket must be screwed to either the FLOOR or REAR
WALL.
Attachmentto Flooror RearWall
Bracket Wall Sill Plate
/Screw mustenter "_
__] wood or concrete
Screw mustenterwood
FLOOR Installation:
WOOD FLOOR: Use the screws provided to secure the
bracket using the pair of marked holes (either Loc A or B).
CONCRETEFLOOR: Using a concrete bit, drill a 5/32" pilot
hole 2" deep into the concrete at the center of each of the
marked holes (either Loc A or B). Use the screws provided to
secure the bracket into the floor.
REARWALL Installation:
Use the 2 screws provided to secure the bracket using the
pair of marked holes at Loc C. The screws MUST enter into
a wood sill plate. If the wall contains ang metal studs or
similar materials, then the floor must be used.
STEP 3 CHECKTHE BRACKET
After installing the bracket, slide the range into its final
location. The rear leveling leg must be fullg inserted into the
ANTI-TIP bracket. If the range has a storage drawer, remove
the drawer and look underneath the range to see if the leg
is fullg engaged in the bracket as shown in Step !.
On models without storage drawer or kickpanel, verifg the
rear leveling leg is properlg secured within the bracket bg
carefullg tipping the range forward. DO NOT tip the range
more than 4 inches. If the bracket does not stop the range
within 4 inches, the bracket is NOT properlg installed and
MUST be reinstalled following these instructions.
A he anti-tip bracket must be PROPERLYINSTALLED and
the rear leveling leg must be FULLY ENGAGED into the
bracket to prevent the range from tipping. NEVER
remove the leveling legs. This will prevent the range
from being secured to the ANTI-TIP bracket properlg.