Preparing The Opening - GE JGP633 Installation Instructions Manual

Installation Instructions
PREPARING THE OPENING
r_ MAINTAIN THE FOLLOWING
MINIMUM CLEARANCE DIMENSIONS
13" MAX. Depth of unprotected
overhead cabinets _ 6" MIN. clearance from
cutout to side wall on the
right of the unit
30" MIN. clearance from countertop
to unprotected overhead surface
18" IVllN.height
from countertop to
nearest cabinet on
either side of unit
3-3/4" MIN. clearance from
cutout to side wall on the
left of the unit
NOTE: Allow 7/16"
minimum vertical
clearance from the
cooktop bottom (or
3-5/8" minimum depth
from the countertop)
to any combustible
surfaces, such as a
cabinet drawer.
For island installation,
maintain 2-1/2 in.
J:
3-5/8"
-f
7/16"
DRAWER
]
minimum from cutout to front and back edge of
countertop. Maintain 3 in. minimum from cutout to
side edges of countertop.
E_ OVERALL COOKTOP DIMENSIONS
, 21" (21-1/4" Max. for
_ _'__3-11/1B" Model ZGU3B)
18-7/8" ._._
F_ CUTOUT DIMENSIONS OF
COUNTERTOP
To ensure accuracy, it is best to make a template
when cuttinq the openinq in the counter.
___19-1/_' width cut
7._ _ ss-7/8"_-c'_ -__
length _ 16-15/16"
2-1/4" Min. Between of cut cutout and the wall
behind the cooktop
2-1/2" Min. from
front edge of cutout
and front edge of
countertop
RECOMMENDED GAS SUPPLY
LOCATION FROM BACKWALL
Recommended
gas supply
location
1" Min. From Backwall
From Cutout
Center Line
I_] MAKE SURE WALL COVERINGS,
COUNTERTOP AND CABINETS
AROUND COOKTOP CAN
WITHSTAND HEAT (UP TO 200°F)
GENERATED BY COOKTOP
Wall covering,
cabinets and
countertop must
withstand heat
up to 200°F
FOR AMERICANS WITH DISABILITIES
ACT (ADA) FORWARD APPROACH
INSTALLATION ON LY:
Allow 5" minimum
depth between the
countertop and an
enclosure.
Y
IL
NOTE: The enclosure must be made of wood
material. Also, an access panel is required for the
electrical outlet, pressure regulator, shut-off valve,
hold-down brackets, and service.