Making The Lp Conversion - GE JGP628 Installation Instructions Manual

Installation Instructions
MAKING THE LP CONVERSION
If sold outside the U.S. and Canada:
-& WARNING: ,fyou
wish to use this product
with Liquefied Petroleum (LP) gas containing greater
than 10% butane, you must purchase a butane
conversion kit. To order,
please call 1.888.664.8403 or 1.787.276.4051.
Model ButGne Kit #
JGP970 WB28T10229
ZGU36 WB28T10229
JGP975 WB28T10231
JGP963 WB28T10233
JGP630 WB28T10235
JGP628 WB28T10236
TOOLS YOU WILL NEED
FOR LP CONVERSION
Phillips-Head
Screwdriver
Pliers
Safety Glasses
7mm Nutdriver
No. 15 Torx-Head
Driver
Small Flat-Head
Screwdriver (4mm or
5/32" tip size, 60mm
long)
r_ SAFETY INFORMATION YOU
SHOULD KNOW
The pressure regulator and burner orifices (]re set
for natural gas. To use LP gas, the regulator and
burner orifices must be converted. The LP orifice
spuds for the cooktop burners can be located in the
literature package attached to the regulator.
--&CAUTION:
The cooktop, as shipped from
the factory, is set for use with natural gas. If you
wish to use your cooktop with LP gas, you must
first replace the orifices and convert the pressure
regulator.
-& WARNING:
This conversion must
be performed by a qualified installer or gas supplier
in (]ccordance with the manufacturer's instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions could
result in serious injury or property damage. The
qualified agency performing this work assumes
responsibility for the conversion.
--&CAUTION:
The following adjustments
must be mode before turning on the burner.
Failure to do so could result in serious injury. Be
sure pressure regulator has been converted as
described in Step 2.
[]
ADJUST YOUR COOKTOP FOR USE
WITH LP GAS
Disconnect oll electrical power, ot the moin
circuit breaker or fuse box.
Shut off the gas supply to the cooktop
by closing the manual shut-off valve.
Adjust the pressure regulator, by the following
instructions:
• Unscrew the cop.
• Ploce your thumb ogoinst the flot side of the
spring retoiner ond press down to remove
the retoiner.
• Carefully look at the spring retainer to locate
the NAT or LP position.
Cop Gosket
/ I---- Spring
/ _ L_JPropone
NAT. Position
Position
Pressure Regulator
• Turn the spring retoiner over so thot
LP is showing on the bottom.
• Snap the retainer buck into position.
• Screw the cup buck onto the regulator.
13