Outside Back Exhaust (Horizontal Duct) - Kenmore 401.8504 Series Installation Instructions Manual

C. OUTSIDE BACK EXHAUST (HORIZONTAL DUCT)
C1. Adapting microwave blower for outside Make
sure
thewires
are
not pinched.
back exhaust NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
1.
6. Secure the blower unit to the microwave with the screw.
Remove and save screw that holds blower Plate to
microwave.
Blower motor screw
2. Lift up the Blower Plate.
Blower motor
of
Microwave
_%_ Back of
Microwave
Blower motor screw
Blower-Plate
From the Mounting Plate
screw
3. Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan Blade Openings Facing
Forward d B
End A
CAUTION: Do not touch blade of blower to prevent
cracking and breaking. Hold outer case when the blower is
removed and re-installed.
4. Rotate blower unit counterclockwise 180° .
7. Attach the exhaust adaptor to the rear of the oven by
sliding it into the guides at the top center of the back of the
oven.
Adaptor
_/ _ Back of
Gulde From Blower motor screw (after attached the
exhaust adaptor)
Push in securely until it is in the lower locking tabs. Take care
to assure that the damper hinge is installed so that it is at
the top and that the damper swings freely.
Before Rotation After Rotation
\
I
Back of Microwave
Back of Microwave
C2. Mount the microwave oven
see page 12-13 (proceed on A1-A3)
5. Place the blower unit back into the opening.
AFTER: Fan Blade Openings Facing
Back
End B
CAUTION: Do not pull or stretch the blower unit wiring.
16