Fuel Shut Off Valve; Cutting Height Adjuster; Bypass Linkages - Husqvarna RZ54i Operator's Manual

Fuel Shut Off Valve

The fuel shut off valve is located at the left rear of the
seat. The valve is off when the handle tab is turned
perpendicular to the fuel line.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.

Cutting Height Adjuster

To set the desired deck cutting height, press the
release button and move the lever forward to the
preset height pin and release the button. See Before
Starting in the Operation section to change the
cutting height. The cutting height range is from 1½"
(38 mm) to 4" (102 mm) in ½" (13 mm) increments.
The heights are measured from the ground up to the
blade tip with the engine not running.
IMPORTANT INFORMATION
To obtain an even cutting height, it is important
that the air pressure in all tires is 15 psi / 103
kPa / 1 bar.

Bypass Linkages

The levers are located on each side of the rear of the
unit below the rear engine plate. The bypass linkage
is used when manually pushing or pulling the unit.
See Moving Machine By Hand in the Operation
section.
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
24
CONTROLS
Fuel shut off valve in the CLOSED position
Mower deck lifting lever
Left side bypass linkage
8011-419
8058-251
8058-0147