Using The Show Interfaces Command - Cisco PA-A2 Installation And Configuration Manual

Atm ces port adapter
Table of Contents

Advertisement

Chapter 4
Configuring the PA-A2 ATM CES Port Adapter
2 Serial network interface(s)
2 HSSI network interface(s)
11 ATM network interface(s)
4 Channelized T1/PRI port(s)
125K bytes of non-volatile configuration memory.
4096K bytes of packet SRAM memory.
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the module slot.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Following is an example of the show diag slot command on a Cisco 7200 series router:
Router# show diag 6
Slot 6:

Using the show interfaces Command

The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify.
For complete descriptions of interface subcommands and the configuration options available for specific
interfaces, refer to the publications listed in the
OL3460-01
ATM WAN OC3+ (MM) Port adapter, 1 port
Port adapter is analyzed
Port adapter insertion time 00:44:57 ago
EEPROM contents at hardware discovery:
Hardware Revision: 1.0
PCB Serial Number:-----H
Part Number:
73-7981-0
Board Revision: 1A
RMA Test History: 00
RMA Number: 00-00-00
RMA History: 00
Unknown Field (type 0088): 00 00 00 01
Product Number: PA-ATM-DBL-DLX-OC3MM
Top Assy. Part Number: 800-20782-01
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 03 A7 41 01 00 C1 8B 2D 20 2D 20 2D 20
0x10: 2D 20 2D 20 48 82 49 1F 2D 01 42 31 41 03 00 81
0x20: 00 00 00 00 04 00 88 00 00 00 01 CB 94 50 41 2D
0x30: 41 54 4D 2D 44 42 4C 2D 44 4C 58 2D 4F 43 33 4D
0x40: 4D C0 46 03 20 00 51 2E 01 FF FF FF FF FF FF FF
0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
"Related Documentation" section on page
PA-A2 ATM CES Port Adapter Installation and Configuration
Checking the Configuration
viii.
4-17

Advertisement

Table of Contents
loading

Table of Contents