Table of Contents
Advertisement
Checking the Configuration
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the show diag slot command, where slot is the port adapter slot in a Cisco 7200 VXR router (with an
NPE-G1 or NPE-G2).
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Following is an example of the show diag slot command that shows a PA-MC-T3-EC in port adapter
slot 2 of a Cisco 7200 VXR router with an NPE-G1 or NPE-G2.
Router# show diag 2
Slot 2:
Enhanced 2 port T3 multichannel Port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time 00:00:50 agoh
EEPROM contents at hardware discovery:
PCB Serial Number : JAE103394R8
Hardware Revision : 1.1
Part Number : 73-10698-02
Board Revision : 06
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Deviation Number : 85586
Product (FRU) Number : PA-MC-2T3-EC
Version Identifier : V01
Top Assy. Part Number : 68-2713-02
CLEI Code :
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF C1 8B 4A 41 45 31 30 33 33 39 34 52 38 40
0x10: 05 44 41 01 01 82 49 29 CA 02 42 30 36 03 00 81
0x20: 00 00 00 00 04 00 88 00 01 4E 52 CB 94 50 41 2D
0x30: 4D 43 2D 32 54 33 2D 45 43 20 20 20 20 20 20 20
0x40: 20 89 56 30 31 20 D9 03 C1 40 CB 87 44 0A 99 02
0x50: C6 8A 20 20 20 20 20 20 20 20 20 20 FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. Following is an example that specifies serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7200 VXR routers, refer to the publications listed in the
page
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
PA-MC-T3-EC Port Adapter Installation and Configuration
5-28
iv.
Chapter 5
Configuring the Channelized Mode
"Related Documentation" section on
OL-10589-02
Advertisement
Table of Contents
