Using Your Radio; Battery Low; Auto Battery Save; Battery Status Indicator - Cobra microTALK CXT345C Owner's Manual

Using Your Radio

Operation
Quick Start
1. Press and hold the Mode/Power button
to turn on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the same
channel/privacy code to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
Turning on Your microTALK
Press and hold the Mode/Power button until you hear
Mode/Power
a series of audible tones indicating the radio is on.
Your microTALK
ready to receive transmissions. The radio is always
in Standby mode except when the Talk, Call or
Mode/Power buttons are pressed.

Battery Status Indicator

The battery charge status is shown on the display.
Battery Charge
Four bars indicates fully charged.
Status
2 English
Radio
®
radio is now in Standby mode,
®
Introduction

Battery Low

Battery Low

Auto Battery Save

Battery Save Mode
Communicating with Another Person
Talk Button
•
Two Inches (5 cm)
from Mouth
•
To Select a Channel
Channel Button
Channel Number
Operation
Customer Assistance Warranty
When battery power is low, the final bar in the Battery
Low icon will blink and an audible tone will sound twice
before the radio shuts off. Your batteries should be
replaced or recharged, if using rechargeable batteries.
The radio will display flashing battery icon
while charging if the radio is on.
If there are no transmissions within 10 seconds, the
radio will automatically switch to Power Save mode
and the Power Saver icon will flash in the display.
This will not affect the radio's ability to receive
incoming transmissions.
1. Press and hold the Talk button.
2. With the microphone about two inches (5 cm) from
your mouth, speak in a normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to the
same channel to communicate.
With the radio on, select any of the 22 channels by
pressing the Channel Up or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared with FRS/ GMRS.
Channels 8 through 14 are FRS only. Channels 15
through 22 are GMRS only.
See page 14 for FRS/GMRS frequency
allocations and compatibility charts.
Nothing Comes Close to a Cobra
•
•
•
•
3
®