Assembly; Stand - Grizzly G1019 Instruction Manual

SECTION 4: ASSEMBLY
Keep clothing rolled up
and out of the way of
machinery
hair pulled back.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them
formed. Please examine
the edges of all metal
parts
them. Failure to do so
could result in injury.
-10-
and keep
after they are
before handling

Stand

The Model G1019 Bandsaw stand is an A-frame,
panel-style stand. The front and rear panels are
connected with one panel at the top and two
cross braces near the bottom.
Sometimes sheet metal parts have a tendency to
''spring'' after they are formed. For this reason,
you may need to use a little extra force to align
holes to insert bolts.
1. Start with the stand panel with the switch
mounted in it. Turn the panel upside down
and attach the rubber feet using (2)
®
1'' Phillips head screws, (2) flat washers
and (2) hex nuts provided. Tighten down.
See Figure 3. Repeat this step with the
second stand panel.
Figure 3. Attach rubber feet first.
1 ⁄ ''-20 x
4
G1019 14'' Bandsaw