Table of Contents
Advertisement
Extension Tables
Components and Hardware Needed:
Large Extension Wing ........................................1
Small Extension Wing ........................................1
Support Leg ........................................................1
Hex Bolt M10-1.5 x 45 ........................................1
Flat Washer 10mm .............................................1
Lock Washer 10mm ............................................1
Cap Screws M8-1.25 x 30 ..................................4
Set Screws M8-1.25 x 20 ...................................2
Lock Washers 8mm ............................................4
Flat Washers 8mm .............................................4
To install the extension tables:
1.
Thread the set screws into the lower holes
in the small extension table. Make sure the
set screws do not stick out from the mating
surface.
Note: Do not completely tighten the bolts in
the following steps until the tables are lev-
eled.
2.
Attach the small extension table with two M8-
1.25 x 30 cap screws, lock washers, and flat
washers as shown in Figure 19.
Note: Get assistance positioning the tables
and holding them in place while installing.
Figure 19. Small extension table attachment.
3.
Attach the large extension table with the
remaining M8-1.25 x 30 cap screws, lock
washers, and flat washers.
-22-
4.
Attach the support leg (Figure 20) to the
table with the M10-1.5 x 45 hex bolt, a lock
washer, and a flat washer.
Qty
Figure 20. Support leg installation.
5.
Check the table surfaces with a straightedge
as shown in Figure 21.
Figure 21. Checking with a straightedge.
6.
Adjust the set screws under the small exten-
sion table to align the surface with the main
table surface.
7.
Use the hex bolt in the support leg to level
the surface of the large extension table.
8.
Tighten all of the cap screws securing the
tables.
G0588/G0591 12" Sliding Table Saws
Advertisement
Table of Contents
