Connecting Lan; Monitor Connection Using Lan - Mitsubishi Electric MDT55IS User Manual

P-7

Connecting LAN

As shown in the illustration below, you can connect this monitor and a computer in network through a LAN hub. Connect the monitor
and the LAN hub using a straight type LAN cable (commercially available).
How to connect
• Turn off the main power switch of the computer and this monitor. If you make a connection while the power is on, it causes a
failure of the devices.
• Connect the computer and the LAN hub using a straight type LAN cable (commercially available).
• Connect this monitor and the LAN hub using a straight type LAN cable (commercially available).
• When you connect two or more monitors, you can connect the monitor and the LAN hub using a straight type LAN cable
(commercially available) as described above.
Computer
(LAN connection)
LAN hub
LAN hub
CAUTION:
Do not connect the CAT5 IN or the CAT5 OUT connector to the LAN connector. If connected, both of the connectors may fail.
NOTE:
• When you use a cross type LAN cable (commercially available), you can connect the monitor and the computer one-to-one
without using a LAN hub, however, the computer may not be supported. It is recommended to check the operation in advance.
• The image transfer function via the LAN isn't supported. This monitor isn't equipped with the host function for controlling other
devices.

Monitor connection using LAN

LAN LAN cable
LAN hub
LAN cable
English-28
Carry out as necessary
Left side of LCD monitor
LAN