Grizzly G1531 Instruction Manual page 11

W W o o r r k k i i n n g g T T a a b b l l e e
1 1 . . Bolt the lead screw bracket to the front of the
stand using the four Hex Bolts already
threaded in place. F F i i g g u u r r e e 4 4 . .
F F i i g g u u r r e e 4 4 . . Lead screw bracket Installed.
2 2 . . Thread the horizontal brace into position, but
do not tighten it down; the brace will require
further adjustment later on. F F i i g g u u r r e e 5 5 . .
F F i i g g u u r r e e 5 5 . . Installing the horizontal brace.
G1531 Edge Sander
3 3 . .
Locate the lead screw / table bracket assem-
bly and the handwheel. Thread the hand-
wheel onto the lead screw about halfway and
insert the lead screw into the lead screw
bracket. F F i i g g u u r r e e 6 6 . .
F F i i g g u u r r e e 6 6 . . Installing the lead screw assembly.
4 4 . . Locate the vertical brace and remove the top
Hex Nut and Flat Washer.
5 5 . .
Turn the horizontal brace approximately 45˚
and insert the vertical brace through the hole
at the end of the horizontal brace. Rotate the
horizontal/vertical brace assembly to 90˚.
6 6 . . Insert the threaded end of the vertical brace
through the hole in the bottom of the table
bracket and re-install the Flat Washer and
Hex Nut back onto the shaft. F F i i g g u u r r e e 7 7 . .
F F i i g g u u r r e e 7 7 . . Horizontal/Vertical brace installed.
-9-