Speaker Connections; Stereo Mode; Parallel Mode - Yamaha XP7000 Owner's Manual

Speaker Connections

Speakers can be connected to the amplifier in three ways, as shown below. Note that speaker impedance will vary according
to the connection method and the number of speakers. Please be sure that your speaker's impedance is not less than the rele-
vant minimum value indicated below.
■

Stereo Mode

Set the Mode switch to STEREO to use the unit as a stereo amplifier. The volume controls on the front panel (A and B) let
you control the volume of each channel independently.
● 5-way binding post
■

Parallel Mode

Set the Mode switch to PARALLEL to use the unit as a two-channnel mono amplifier. The volume controls on the front
panel (A and B) let you control the volume of each channel independently.
Note: In this case, the loads for A and B are connected directly in the amplifier. Make sure not to input any signal
to the B terminal.
● 5-way binding post
8
XP7000/XP5000/XP3500/XP2500/XP1000 Owner's Manual
● Speakon connector
+ +
– –
4Ω* 4Ω*
* Minimum speaker
impedance
● Speakon connector
+ +
– –
4Ω* 4Ω*
* Minimum speaker
impedance
4Ω* 4Ω*
* Minimum speaker
impedance
4Ω* 4Ω*
* Minimum speaker
impedance