Adjusting Depth - Grizzly H7949 Instruction Manual

Adjusting Depth

To adjust the nail depth:
Adjusting the depth of nail penetration is
done by turning the adjustment knob locat-
ed near the trigger as shown in Figure 12.
Figure 12. Depth adjustment knob.
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Turn the depth adjustment knob to
increase or decrease nail penetration:
— If you want to increase the nail
depth, then turn the adjusting knob
counterclockwise.
— If you want to decrease the nail
depth, then turn the adjusting knob
clockwise.
3. Connect the nailer to the air supply,
test the nail depth, and repeat this
entire procedure if necessary until the
nail depth is satisfactory.
-12
-
Depth Adjustment
Knob
Clearing Jammed
Nails
A jammed nail must be cleared before the
nailer is used again.
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Remove all nails from the magazine.
3.
Use a steel rod and hammer to tap the
jammed nail back into the magazine
driving hole as shown in Figure 13.
Jammed Nail
Figure 13. Tapping a jammed nail back
into the magazine driving hole.
4. Use a screwdriver to pry the jammed
nail out of the driving hole as shown in
Figure 14.
Figure 14. Prying a jammed nail from the
driving hole.
H7949/H7950/H7951 Nailer