Truss Rod Cover; Winding Strings - Grizzly H8181 Owner's Manual

Truss Rod Cover

Components and Hardware Needed:
Guitar ................................................................. 1
Truss Rod Cover ............................................... 1
Screw #2 x ⁄ " ................................................... 1
3
8
To install the truss rod cover:
1. Center the truss rod cover over the hole for
the truss rod and press it against the nut.
2. Mark the mounting hole, use a
drill a ⁄ " deep hole into the headstock, and
3
8
secure the truss rod cover with the #2 x
screw.
Figure 26. Truss rod cover installed.
H8180/H8181 Bass Guitar Kit
Qty
⁄ " drill bit to
1
16
⁄ "
3
8
#2 x ⁄ "
3
8
screw

Winding Strings

The correct position of the guitar strings is shown
in Figure 27. The thin high "G" string is the "1st"
(bottom) string and the thick low "E" string is the
"4th" (top).
Components and Hardware Needed:
Guitar ................................................................. 1
Strings ............................................................... 4
� �
� �
�
�
�
�
�
Figure 27. Example of correct string locations.
To install the strings:
1.
Thread a string through the hole in the bridge
(Figure 28) across the saddle, over the nut,
and through the hole in the corresponding
tuning post.
Figure 28. 1st string installed.
Qty
Saddle
-17-