Advertisement
10. Remove four screws that fasten the left and right
vehicle brackets. Pull the heater control unit and
pocket out toward you, and unplug the vehicle
connectors.
VEHICLE 20-PIN
CONNECTOR
HEATER
CONTROL UNIT
LEFT
VEHICLE
BRACKET
SCREW
11. Remove the left and right vehicle brackets (six
self-tapping screws), and separate the heater
control unit from pocket. Set the pocket aside, it
will not be reused.
SELF-
TAPPING
SCREW
LEFT VEHICLE
(reuse.)
BRACKET
(Not reused.)
SELF-
TAPPING
SCREW
POCKET
4 of 6
VEHICLE 30-PIN
CONNECTOR
POCKET
RIGHT
VEHICLE
BRACKET
HEATER
SELF-
CONTROL UNIT
TAPPING
SCREW
(reuse.)
SELF-
RIGHT
TAPPING
VEHICLE
SCREW
BRACKET
(Not reused.)
12. Install the DIN bezel to the player. Set the heater
control unit on the player, and attach the left and
right player brackets to the player and the heater
control unit using the two self-tapping screws
removed in step 11 and four 5 x 8 mm washer-
screws included with the player.
SELF-TAPPING SCREW
(Removed in step 11.)
LEFT PLAYER
BRACKET
5 x 8 mm
WASHER
SCREW
(Included with
the player.)
Installing the Player
13. Route the bus cable from the audio panel opening
to the heater control unit opening. Using one wire
tie, secure the bus cable to the vehicle harness.
VEHICLE
HARNESS
30 mm
All 30488 (0509)
HEATER
CONTROL
UNIT
DIN BEZEL
PLAYER
RIGHT
PLAYER
BRACKET
BUS CABLE
14-PIN
CONNECTOR
WIRE TIE
TO AUDIO UNIT
HEATER
CONTROL
UNIT
OPENING
5426240Y
©
2005 American Honda Motor Co., Inc. - All Rights Reserved.
SELF-
TAPPING
SCREW
(Removed
in step 11.)
5 x 8 mm
WASHER
SCREW
(Included
with the
player.)
5715030Y
AUDIO
PANEL
OPENING
BUS
CABLE
Advertisement
