Table of Contents
Advertisement
Installation
Work on the cooker must be carried out by a
QUALIFIED ELECTRICIAN
Certain edges and corners which will not normally
be exposed may be sharp.
the cooker.
Before installing the cooker, you should check that its
dimensions correspond to the rest of your kitchen units.
Measure the height of the worktop from floor to top surface
of the worktop, and the plinth depth from the wall to the
front edge of the plinth (
be installed adjoining one wall, or one tall unit.
When delivered, the cooker plinth is adjusted to suit a
worktop height of 90 cm and a plinth depth of 55 cm. Where
necessary, you can alter the height of the plinth to make the
cooker suitable for a worktop height of 85 or 88 cm (see
below). Check the cooker cable is not trapped when moving
the cooker.
To adjust the plinth height
1 Carefully lay the cooker on its front (
Use some of the packaging material to cushion the
cooker on the floor surface.
2 Take care: there are sharp edges on the underside of
the cooker. Unscrew screw A (1 screw) in the centre
rear of the plinth and the side screws B (4 screws,
).
PICTURE
3 Push the plinth in to the required height setting, 90,
88 or 85 cm (
SEE PICTURE
4 Screw in screws A and B again.
Levelling the cooker
The cooker must be level, for example to ensure that oil in
frying pans is of even depth. To check whether the cooker is
level, place a spirit level or a frying pan filled with water on
the hob.
If necessary, you can lower (-6 mm) or raise (+12 mm)
the wheels and feet, working from the front of the cooker.
Use a screwdriver to adjust the rear wheels, and adjustable
pliers for the front feet.
. The cooker is heavy.
when moving
USE GLOVES
). The cooker may also
SEE PICTURE
SEE PICTURE
).
).
B
A
B
SEE
Installation
90
88
85
55
B
B
90
88
85
17
Advertisement
Table of Contents
