What To Do When - AEG FAVORIT 84470 VI User Information

Operating instructions

What to do when...

Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call in customer service to resolve one
of the malfunctions listed here, or rectify an error made in the
operation of the appliance, the customer service engineer's visit is not
free of charge, even during the period of guarantee.
...Error messages are displayed.
If your appliance is equipped with an optical floor signal, in the event
of an error a dot-shaped optical signal will flash on the floor.
Errors will only be indicated acoustically if the acoustic signal has been
activated.
If, as listed in the table below, any of the indicators in the control
panel or the display panel are flashing or are illuminated, and/or if an
acoustic signal can be heard, you can probably rectify the fault
yourself.
Malfunction
One continuously
repeated warning tone
can be heard; the cycle
indicator for the
selected cycle is
flashing:
Error code
displayed in the multi-
display: There is no water
running into the
dishwasher.
24
Possible cause
The tap is blocked or
furred with lime-scale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked
is
Filters in the base of the
washing compartment are
blocked.
The water inlet hose has not
been correctly laid.
Remedy
Clean tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
commenced dishwashing
cycle; then abort the
dishwashing cycle by
pressing RESET (see chapter:
Starting a dishwashing
cycle); Clean out the filters.
(See chapter: Cleaning the
filters).
Check hose installation.